Fibre, structured cabling and networking
Inside plant and outside plant fibre, copper and fibre structured cabling, and complete networks for villas, towers, offices and server rooms. Our field teams carry out e& (Etisalat) fibre work orders across Dubai.
Most of our work starts with a cable. We pull fibre into towers and villas, run copper and fibre structured cabling through offices and server rooms, and set up the network equipment at the end of it. Our field teams also carry out e& (Etisalat) fibre work orders across Dubai.
Fibre inside the building
Inside plant (ISP) work covers everything between the building entry and the flat or office. We run fibre up the risers, through trunking and conduits, and along the floor distribution to each unit. Before we pull anything we walk the route, check that the containment has space, and plan where joints and termination points will sit.
Fibre outside the building
Outside plant (OSP) work takes the cable from the network to the building. That can mean pulling through ducts and manholes, blowing cable into microducts, or running aerial and direct-buried routes where the site calls for it.
FTTH and last-mile connections
For fibre to the home (FTTH) and other FTTx jobs, we install the GPON drop cable, take it the last mile into the premises and terminate it inside the home so the service provider's equipment can be connected.
Splicing and testing
We join fibre by fusion splicing and house the joints in closures, ODFs and patch panels. Every link is tested with an OTDR and a power meter and light source. You get the results with the as-built report, so you have a record of each run and its loss.
Structured cabling
For offices, towers and server rooms we install Cat6, Cat6A and Cat7 copper cabling with a fibre backbone between floors or rooms. We supply and fit single-mode and multi-mode fibre, MPO/MTP trunks, pigtails and patch cords, and build the racks, cabinets, cable trays and containment that hold it. Every point is labelled so it can be traced later, and copper links are certified and tested before handover.
Networks
Once the cabling is in, we install and set up the switches, routers and Wi-Fi access points for LAN, WAN and wireless networks. Data centre and server room cabling is handled by the same team.
Faults and maintenance
If a link is down or a network point has stopped working, we find the fault, repair it and test the line again. We also maintain existing cabling and fibre installations.
What is included
- ISP fibre pulling: risers, trunking, conduits and in-building distribution
- OSP fibre: duct and manhole pulling, cable blowing, aerial and direct-buried routes
- FTTH and FTTx: GPON drop cables, last-mile and in-home termination
- Fusion splicing, joint closures, ODFs and patch panels
- OTDR, power meter and light source testing with as-built reports
- Structured cabling: Cat6, Cat6A and Cat7 copper with fibre backbone
- Single-mode and multi-mode fibre, MPO/MTP trunks, pigtails and patch cords
- Racks, cabinets, cable trays, containment and labelling
- LAN, WAN and Wi-Fi networks: switches, routers and access points
- Data centre and server room cabling
- Copper link certification and network point testing
- Fault location, repair and maintenance